IP-L5002BICEPS CURLOWNERS MANUAL -INSTALLATION INSTRUCTIONS
Exclusive warrantiesTHIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES OF ANY KIND EITHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE
INSTALLATION INSTRUCTIONS11• 5mm Hex Key Socket…………………………………... • 6mm Hex Key Socket……………………………………111• 13mm Box / Open-End Wrench ………………...• 13mm
STEP #1 - UNPACK AND ASSEMBLE MAIN FRAME:1. Remove and unwrap all product from shipping boxes. Lay all parts out in a clean open area to prepare for a
STEP #2 - ASSEMBLE LEVERAGE ARMS:1.Locate one of the LEVERAGE ARMS, slide it onto the corresponding shaft as show below, the side of the leverage arm
STEP #3 – ASSEMBLE CAM ASSEMBLY AND LEVERAGE CURL ARMS :1. Slide one of the CAM ASSEMBLYS onto the mount of the Main Frame as shown, the side of CAM
STEP #4: INSTALL BELT1. Install the BELT PIVOT MOUNT onto the LEVERAGE ARM, using one (M16x45MM SHOULD BOLT), two (M16 FLAT WASHER), and one (M12 N
STEP #5: INSTALL SEAT ASSEMBLY1. Install SEAT ASSEMBLY and ASSEMBLY FROM STEP #4, using four (M8x16MM SOCKET HEAD BOLTS), four (M8 FLAT WASHER) as sh
STEP #6 – INSTALL WEIGHT STORAGE, BEARING END CAPS:1.Install the WEIGHT HORN weldment and BACKING PLATE using two (M8 X 75MM, SOCKET HEAD BOLTS) fou
HARDWAREPage 18
FINAL ASSEMBLE CHECK SHEET1. Make sure ALL fasteners are tightened to specifications is this manual.2. See Maintenance and Service page.1. Perform all
Page 2Copyright 2011. Star Trac by CORE INDUSTRIES. All rights reserved, including those to reproduce this book or parts thereof in any form without f
Part No. 620-8082, Rev A.,MARCH 2011STAR TRAC14410 Myford RoadIrvine, California 92606Telephone: (800) 228-6635, (714) 669-1660Fax: (714) 508-3303www.
TABLE OF CONTENTS• SAFETY INSTRUCTIONS / WARNINGS• WARNING LABLES WITH PART NUMBERS• EXERCISE GUIDELINES• MAINTENANCE AND SERVICE• WARRANTY COVERAGE•
Safety InstructionsLEVERAGE Safety Information and General Exercise GuidelinesSafety InformationRead the LEVERAGE Owner's Manual carefully before
13. SECURING EQUIPMENT: All STAR TRAC equipment MUST be secured to the floor to stabilize and eliminate rocking or tipping over. This must be perform
Page 6731-2991
Exercise Guidelines• Like most exercise, strength training involves an element of risk. Utilize this information to assist you and/or your members in
MAINTENANCE AND SERVICELEVERAGE requires very little upkeep to keep your equipment performing at its best, the following guidelines are suggested.GENE
Warranty CoverageStar Trac commercial exercise equipment (.Product.) is warranted to be free of all defects in material and workmanship. Star Trac war
Commentaires sur ces manuels