Star-trac Pro Upright Bike Manuel d'utilisateur télécharger pdf (Page 12)

12 STAR TRAC PRO BIKES O

WNER

’

UIDE

3. Install the Seat Post

Carefully slide the seat post into the seat tube.

Pull out on the seat release knob, and slide the seat post fully into

the seat tube. Release the seat release knob.

Install two M4 X 20 socket head screws into the seat sleeve to

secure it. Tighten the screws securely using the 3mm hex wrench.

Install the M6 X 10 socket head screw into the hole in the back of

the seat tube. Using the 4mm hex wrench, tighten the screw

securely.

4. Install the Display Console

NOTE: It may be necessary to have one person support and posi-

tion the display console while a second person makes the cable

connection.

Carefully slide the display console neck approximately one inch

onto the neck brackets of the bike frame. With the console partial-

ly supported by the neck brackets, plug the display console cable

into the receptacle on the bike frame.

CAUTION: Be careful not to pinch your fingers between the console

neck and the bike frame when sliding the console into place.

CAUTION: Be sure not to pinch the display cable between the con-

sole neck and the bike frame.

Carefully slide the console neck onto the neck brackets until it is

fully seated. Secure the display console to the frame with four M6

X 16 flat head screws (two screws in front side and two screws in

back side). Using the 4mm hex wrench, tighten all four screws

securely.

5. Install the Pedals

Install the pedals on the pedal cranks using a 5/8-inch open-end

wrench. Tighten the pedals securely.

NOTE: Turn the left pedal spindle counterclockwise when thread-

ing into the crank arm; turn the right pedal spindle clockwise

when threading into the crank arm.

Step 3

Step 4A

Step 4B

Step 5

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Pas de commentaire

Star-trac Pro Upright Bike Manuel d'utilisateur Page 12